Wrap Care

Caring For Your Graphics

wrapcare.jpg

Do NOT wax vehicle prior to install.


Paint must be free of defects, if it is not owner of the vehicle waves all warranty in those areas.


A 1 month follow up appointment to complete registration of warranty is necessary.

Any missed appointments will void all warranty.


All Out Wraps does not warranty the following areas; around gas door, high traffic areas such as handles, rocker panels, wheel wells, door steps, rolling windows,
windows with windshield wipers or ANY plastic areas

Care Guide
Wash Regularly
Wash whenever the car appears dirty.
Contaminants allowed to remain on the graphic may be more difficult to remove during cleaning.
Rinse off as much dirt and grit as possible with a spray of water.
Use a wet, non-abrasive detergent such as 3M™ Car Wash Soap 39000 or Meguiar’s NXT Generation®
Car Wash or Deep Crystal® Car Wash and a soft, clean cloth or sponge.
Rinse thoroughly with clean water.
To reduce water spotting, immediately use a silicone squeegee to remove waterand finish with a
clean microfiber cloth.
Pressure Washing
Although hand washing is the preferred cleaning method, pressure washing may be used under
these conditions.


•DO NOT USE AUTOMATIC CAR WASH- as the pressure exceeds 2000 psi
-Ensure the water pressure is kept below 2000 psi (14 MPa).
• Keep water temperature below 180 °F (80 °C).
• Use a spray nozzle with a 40 degree wide angle spray pattern.
• Keep the nozzle at least 1 foot (300 mm) away from and perpendicular (at 90 degrees) to the graphic.